Improve droop travel, drivability and tire wear as well as adjusting tire position in your wheel well with SPC's adjustable front upper control arms for the Ford Ranger (T6 Platform). Featuring our long - life maintainable ball joint and SpecRide bushings, this arm is designed to correct alignment angles while maintaining factory ride quality. SPC's integrated tubular and cast steel design provides the strength and durability needed for the most demanding environments. These remove and replace arms are available in pairs for lifted and off - road applications. Get more droop travel SPC's arm has improved clearance to get around the spring bucket when the arm droops, eliminating arm to frame contact on lifted trucks. The maintainable ball joint has an oversized ball and allows more than 80 of articulation to ensure it never binds. SpecRide bushings have free pivot to eliminate any chance of bushing failure seen on many high travel suspensions. Get your drivability and tracking back When you lift your truck you affect caster and camber. SPC's arms have 1 of caster built into them. Using its patented ball joint design the arm will get you - 1 to 4 of caster and 3 of camber. Get your tire where you want it in the wheel well Use adjustment in the control arm and on the OE lower cams to maximize alignment angles and move oversized tires forward in the wheel well to minimize or avoid fender trimming. Note This Arm Pair has internation applications only, 25660 does not fit North American models. This Arms pair fits the following applications in specific regions 2012 - 2019 Ford ranger T6 4WDRWD in the European and Mexican Regions, 2011 - 2018 Ford Ranger T6 4WDRWD in the Asian Regions, 2012 - 2018 Mazda BT - 50 RWD4WD in the Asian Regions, 2012 - 2014 Mazda BT - 50 RWD4WD in the European Regions.